XJR (X300) L6-4.0L SC (AJ16) (1995)
/l6-4.0l_sc_(aj16)/Page-1860002.png)
5. Remove and discard rubber buffer from filler flap.
Installation
1. Fit new rubber buffer to filler flap.
2. Fit striker to filler flap.
3. Ensure that magnet location is clean and snap-fit magnet to filler flap.
4. Locate filler flap studs in hinge plate and fit and tighten securing nuts.
5. Connect ground cable to battery terminal and fit battery cover. Refer to 'Battery, Service and Repair, Battery Reconnection Procedure.' See:
Starting and Charging/Battery/Service and Repair
