XJR (X300) L6-4.0L SC (AJ16) (1995)
Sunroof / Moonroof Module: All Technical Service Bulletins
Sliding Roof Control Module - Removal and Installation
13-34
SEDAN RANGE
DATE: 11/97
Sliding Roof Control Module (SRCM ) - Avoiding Breakage - Removal &
Installation Procedure - Not In Manual
MODEL
1995-97 MY
SEDAN RANGE
VIN
720001-812255
ISSUE:
This bulletin provides a procedure for removing the Sliding Roof Control Module (SRCM) without damaging the retaining clips.
ACTION:
When removing the SRCM on a 1995-97 MY Sedan Range vehicle, refer to the following procedure to avoid damage:
REMOVING SRCM
1.
Remove the sliding roof trim panel assembly.
2.
Remove the sliding roof flange finisher.
3.
Remove the roof console for access.
4.
Remove the right side sun visor support block.
5.
Carefully lower the front edge of the headlining for access to the SRCM.
CAUTION:
Use care not to damage the headlining when pulling it down.
6.
Disconnect both harness connectors from the SRCM.
7.
Remove the tie strap, if so equipped.
8.
Feel under the SRCM until the retaining clip (A, Illustration 1) can be felt on the side of the SRCM. Press the retaining clip toward the ECM.
9.
With the retaining clip depressed, swing the SRCM down in the direction of arrow B until the clip is free of the opening in the vehicle structure.
10.
Move the SRCM sideways in the direction of arrow C until releases from retaining tab D. Remove the SRCM from the vehicle.
INSTALLING THE SRCM
The sliding roof panel must be correctly positioned and the SRCM synchronized before it is installed in the vehicle (Illustration 1).