XJR (X300) L6-4.0L SC (AJ16) (1995)
Impact Sensor: Service and Repair
Airbag Crash Sensor (Headlamp Cavities)
Airbag Modules
-
Disconnect the battery and wait for one minute before attempting sensor removal.
-
Disconnect sensor harness from forward airbag harness.
-
Remove upper sensor fixing from bonnet hinge mounting bracket.
-
Remove lower sensor fixing and sensor from vehicle.
-
Disconnect the harness (yellow) connector.
-
Examine the sensor, including the harness, for any damage. Renew if necessary.
NOTE: Examine sensor and sensor harness for damage, renew if necessary. Renew sensors if vehicle has been involved in a collision. Arrows stamped
on the sensor bracket shows orientation in car (points forward).
'L' or 'R' identifies LH or RH mounting. After the vehicle has been involved in a collision, both sensors must be renewed if damage has occurred
to headlamp mounting panel, headlamp assembly, bonnet hinge mounting panel, front longitudinal members, bonnet/bonnet hinges and front
mounting structure.