XJR (X300) L6-4.0L SC (AJ16) (1995)
Band Apply Servo: Service and Repair
Front Servo Assembly, Renew
^
Raise hood and fit wing cover.
^
Raise the vehicle on a ramp.
^
Drain the transmission lubrication system.
^
Remove the fluid pan.
^
Remove the fluid filter.
^
Remove the transmission internal harness multipin socket O-ring.
^
Remove the internal lubrication pipe.
^
Remove the manual detent spring assembly.
^
Remove the internal dipstick stop.
^
Remove the valve body and accumulator assembly, check the condition of the gasket.
^
Place front servo piston, pin and spring assembly aside, see Fig. 1.
^
Place new front servo assembly to front.
^
Lubricate servo piston assembly.
^
Refit front servo assembly.
^
Refit the valve body assembly, checking that all nine checkballs are in their correct positions.
^
Refit internal dipstick stop.
^
Refit manual detent spring assembly.
^
Refit internal lubrication pipe.
^
Fit new internal harness multipin socket O-ring seal.
^
Refit fluid filter.
^
Refit fluid pan.
^
Lower the vehicle on the ramp.
^
Refill the transmission with fluid.