XJR (X300) L6-4.0L SC (AJ16) (1995)
Transmission Speed Sensor: Service and Repair
Output Speed Sensor
OUTPUT SPEED SENSOR, RENEW
-
Raise the vehicle on a ramp.
-
Reposition the edge of the transmission tunnel sound insulation foam for access.
-
Disconnect the harness plug from the output speed sensor.
-
Release and remove the speed sensor securing bolt.
-
Reposition the speed sensor protection cover for access, noting that the cover remains captive on the harness.
-
Remove the speed sensor from the transmission unit and place aside.
-
Clean the main case speed sensor area.
-
Fit a new '0' ring seal to a new output speed sensor.
-
Lubricate the '0' ring seal.
-
Fit and seat the speed sensor to the main case.
-
Reposition and align the speed sensor protection cover.
-
Fit and tighten the speed sensor securing bolt.
-
Connect the harness plug to the speed sensor.
-
Reposition the edge of the transmission tunnel sound insulation foam to the original position.
-
Lower the vehicle on the ramp.