XJR (X300) L6-4.0L SC (AJ16) (1995)
Pressure Regulating Solenoid: Service and Repair
VARIABLE FORCE MOTOR, RENEW
-
Open the hood and fit a suitable fender cover.
-
Raise the vehicle on a ramp.
-
Drain the transmission lubrication system.
-
Remove the fluid pan.
-
Remove the fluid filter.
-
Disconnect the internal harness plug from the variable force motor.
-
Release and remove the motor retaining clamp to valve body securing screw (1 Fig.1).
-
Remove the retaining clamp (2 Fig.1) and remove the motor (3 Fig.1) from the valve body and place aside.
-
Fit a new variable force motor to the valve body.
CAUTION: Do not adjust the motor screw and ensure that the motor filter is not damaged.
-
Align the motor.
-
Fit the motor to the valve body retaining clamp.
-
Fit and tighten the motor retaining clamp securing screw.
-
Connect the internal harness plug to the motor.
-
Refit the fluid filter.
-
Refit the fluid pan.
-
Lower the vehicle on the ramp.
-
Refill the transmission unit with fluid.
-
Remove the fender cover and close the hood.