XJR (X308) V8-4.0L SC (AJ26) (1998)
Front Bumper Reinforcement: Service and Repair
Removal
WARNING:
ENSURE THAT ALL PERSONNEL AND EQUIPMENT ARE CLEAR OF AREA BEFORE OPERATING RAMP.
1. Position vehicle on 4-post ramp.
2. Remove battery cover and disconnect ground cable from battery terminal. Refer to 'Battery, Battery Cable.' See: Starting and
Charging/Battery/Battery Cable/Negative
3. Remove radiator surround and grill.
4. Raise ramp to working height.
5. Using wheel-free lifts, remove front wheels.
6. Remove wheelarch liners for access.
7. Remove undertray.
8. At each side of vehicle:
Disconnect fog lamp, direction indicator and sidemarker lamp (where fitted) harness multiplugs. If headlamp powerwash is fitted, remove and
discard plastic clip from hose and disconnect hose at RH side of bumper.
9. Slacken and remove bolts securing bumper assembly to mounting struts.
10. Lower 4-post ramp.