XJR (X308) V8-4.0L SC (AJ26) (1998)
Front Door Window Glass: Service and Repair
Removal
1. Remove battery cover and disconnect ground cable from battery terminal. See: Starting and Charging/Battery/Battery Cable/Negative/Service and
Repair
2. Remove front door casing.
3. Remove water shedder carefully guiding harness through penetration, and place adhesive face down on clean polythene sheet.
4. Position PVC weathershield for access.
5. Remove front door module.
6. Remove front door glass lift motor and regulator assembly. Refer to Window Regulator, Service and Repair. See: Front Door Window
Regulator/Service and Repair
7. Supporting glass, remove tape securing it to top of door for motor removal.
8. Withdraw glass upwards through aperture and out via outboard side of frame.
Installation
1. Position glass in frame aperture.
2. Locate leading edge of glass in seal of front channel.