XJR (X308) V8-4.0L SC (AJ26) (1998)
6. Remove hinge from vehicle.
Installation
1. Fit and tighten bolts securing hinge to BIW saddle panel.
2. Fit but do not tighten bolts securing hinge to trunk lid.
3. Ensuring that harness is clear (RH hinge only), carefully close trunk lid and check and adjust lid alignment as necessary.
4. Tighten bolts securing hinge to trunk lid.
5. Fit gas strut rod end to hinge pivot ensuring that securing clip fully seats.
6. Using new tie straps, secure harness to trunk hinge (RH hinge only).
7. Fit cover to hinge.