XJR (X308) V8-4.0L SC (AJ26) (1998)
/v8-4.0l_sc_(aj26)/Page-495007.png)
11. Install the crankshaft position sensor.
Install the sensor to the flywheel housing and fit the securing bolt. Tighten to 8-12 Nm. Install the access grommet to the housing.
12. Lower the ramp.
13. Remove the paint protection sheets and close the engine compartment cover.
14. Connect the battery and install the battery cover.
Refer to the Battery Reconnection Procedure in Starting and Charging.