XJR (X308) V8-4.0L SC (AJ26) (1998)
/v8-4.0l_sc_(aj26)/Page-504002.png)
9. Remove the chain guide.
Remove the bolt, which secures the chain guide.
Note the orientation of the chain guide and remove it from the upper retaining pin.
10. Clean and inspect all relevant components.
Installation
1. Install the chain guide.
The chain guide must be installed so that the slotted hole is towards the top, and the raised shoulder to the cylinder block.
Install the chain guide to the block and locate it onto the upper retaining pin.
Install the retaining bolt and tighten it to 10-14 Nm.
2. Remove the Ty-Strap from the chain.
3. Install the Timing Chain Tensioner- Primary. The camshafts may need to be turned slightly to provide slack in the chain, on the tensioner side.
4. Install the VVT Bush Carrier Assembly.
5. Install the Timing Cover.
6. Move the engine compartment cover from the service position and connect the gas struts.
7. Remove the paint protection sheets and close the cover.
8. Connect the battery and install the battery cover.
Refer to the Battery Reconnection Procedure.
