XJR (X308) V8-4.0L SC (AJ26) (1998)
4. Remove fuel injector.
Pry out injector retaining clip, ensuring that it is not ejected and lost. Note orientation of clip.
Using a suitable implement, carefully lever injector from fuel rail.
Discard injector O-rings.
5. Clean all mating faces.
Installation
1. Install fuel injector.
Install new O-rings, lubricated with petroleum jelly, to fuel injector.
Install fuel injector into fuel rail. Press firmly until it is felt to click into place.
Hold injector firmly down and install injector securing clip in correct orientation.
2. Re-connect injector and harness connectors.
3. Tighten harness nut to 4-5 Nm.
4. Reconnect battery ground cable. Refer to 'Battery, Service and Repair, Battery Reconnection Procedure.' See: Starting and
Charging/Battery/Service and Repair