XJR (X308) V8-4.0L SC (AJ26) (1998)
Fuel Rail: Service and Repair
Pipe - Inlet Manifold Fuel Cross-Over
Removal
WARNING:
BEFORE PROCEEDING, IT IS ESSENTIAL THAT ALL 'SERVICE PRECAUTIONS' ARE READ AND UNDERSTOOD.
1. Depressurize fuel system; See: Fuel Filter/Fuel Pressure Release/Service and Repair
2. Disconnect battery ground cable. Refer to 'Battery, Battery Cable.' See: Starting and Charging/Battery/Battery Cable/Negative
3. Remove inlet manifold fuel cross-over pipe.
Place cloth under pipe elbows to collect any spillage.
Remove elbow securing screws.
Disconnect first elbow.
Disconnect remaining elbow and remove assembly.
Discard O-ring seals from pipe elbows.
Clean relevant parts and mating faces.
Installation
1. NOTE: Install and lubricate new O-ring seals.