XJR (X308) V8-4.0L SC (AJ26) (1998)
8. Remove the drive flange assembly
Use tool JD 156 (puller) to remove the drive flange/seal assembly
9. Clean the seal counterbore
Installation
1. Installation is the reverse of the removal procedure, noting the following;
2. Lightly lubricate the seal O/D
3. Check for the correct assembly condition
Ensure that the seal, Ryton ring & backing are aligned & in contact with each other
4. NOTE: Correct pinion seal location is automatic
'Pull' the pinion flange/seal assembly down with the pinion nut - do not hammer the flange
5. Refer to the illustration
Rotate the pinion prior to final tightening
Stake the nut to the pinion