XJR (X308) V8-4.0L SC (AJ27) (2000)
4.
Use the dial indicator gauge to check for disc run-out (illustration 1). If excessive run-out is present recheck the condition of the mating faces.
5.
If run-out is still present, reinstall the disc in a new location, i.e. index the disc to a new position on the studs and recheck for run-out.
6.
Continue to rotate the disc as before until all positions have been checked or the run-out has been reduced to below the minimum stated above.
7.
If run-out is still present install a new disc and recheck for run-out.