XJR (X308) V8-4.0L SC (AJ27) (2000)
48. Remove wire temporarily supporting hub assembly.
49. Remove wishbone/hub assembly from crossbeam.
-
Supporting hub assembly, withdraw lower wishbone eccentric bolts.
-
Supporting hub assembly, withdraw fulcrum shaft from upper wishbone.
-
Remove wishbone/hub assembly from crossbeam.
-
Repeat procedure to remove wishbone/hub assembly on opposite side.
50. Remove crossbeam front mountings.
-
Remove front mounting heatshield.
-
Remove four bolts securing mounting to crossbeam.
-
Repeat procedure to remove mounting on opposite side.
Installation
Installation
1. Install front mounting brackets.
-
Position and fully seat mounting bracket on crossbeam.
-
Install the four bolts and tighten to 22-28 Nm.
-
Install heatshield.
-
Repeat procedure to install mounting bracket on opposite side of crossbeam.
2. Install upper wishbone/hub assemblies on crossbeam.
-
Position upper wishbone on crossbeam.
-
Install fulcrum shaft threaded end facing rearward.
-
Install fulcrum shaft securing nut and tighten to 60-80 Nm.
-
Repeat procedure to install opposite side upper wishbone/hub assembly.