XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-2041002.png)
3. Withdraw trim pad front tang from toeboard and remove trim pad.
Installation
1. Position trim pad at 'A' post and engage retainer on securing stud. For access at driver side it will be necessary to pull and hold hood release lever
rearwards.
2. Ensuring that tang engages in toeboard carpet slot, push trim pad forward to fully seat retainer on stud.
3. Fit draught welt section and treadplate.
Ensure that lower rear draught welt section is fully seated on aperture flange.
Fit and fully seat front welt section over aperture flange aligning end with panel joint.
Position sill tread plate and fit and tighten three securing screws.
Fit treadplate finisher. If finisher has been renewed, remove protective film.
