XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-2083002.png)
9. Carefully remove and discard retaining stud from LH end of header seal.
10. Lift rear edge of seal for access and slacken and remove latch cover LH securing screw.
11. Remove and discard retaining stud from RH end of header seal, lift rear edge of seal and slacken and remove latch cover RH securing screw.
12. Slacken and remove the latch cover center securing screws and remove latch cover from header rail.
Installation
Installation
1. Position latch cover on header rail and fit and tighten center securing screws.
2. Lift RH edge of header seal for access and fit and tighten the latch cover RH securing screw.
3. Fit and fully seat new retaining stud to RH end of header seal.
4. Lift LH edge of header seal for access and fit and tighten the latch cover LH securing screw.
