XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-2086002.png)
10. Identify and mark position of inboard hoses relative to pump, disconnect hoses, remove and discard 'O' ring seals and fit blanks to pump and hose
connectors.
11. Slacken and remove the two pump assembly securing bolts.
12. Remove pump from mounting.
Release pump from outboard grommet locations and position pump for access to outboard hoses. Identify and mark position of outboard hoses
relative to pump, disconnect hoses, remove and discard 'O' ring seals and fit blanks to hose and pump connectors.
13. Remove pump from trunk.
14. If pump is to be renewed:
Remove and retain mounting rubbers from pump.
Remove connector blanks.
Slacken and remove pump reservoir filler plug
Invert pump over a suitable receptacle and allow fluid to completely drain.
