XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
-
Apply grease to forked end of brake booster push-rod.
-
Install gasket to brake booster.
2. Align brake booster assembly to pedal housing, make sure push-rod fork straddles brake pedal.
-
Install nuts and tighten to 22 - 28 Nm.
3. Connect brake pedal to brake booster push-rod.
-
Apply grease and install clevis pin.
-
Install clevis-pin clip
4. Install stoplamp switch to pedal housing.
-
Install nuts and tighten to 3 Nm.
5. Install pedal housing, brake booster and master cylinder assembly.