XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-453013.png)
13. Tighten the exhaust camshaft sprocket securing bolt.
Install the chain tensioner tool 303-532 to the sprocket holes.
Apply force to the tool in an anti-clockwise direction to tension the chain on its drive side.
Whilst applying the opposing force to the sprocket and chain, tighten the sprocket securing bolt to 115 - 125 Nm.
14. Tighten the VVT unit securing bolt.
Whilst still applying the opposing force to the sprocket and chain (using 303-532), check that the wedges are still in place, tighten the VVT unit
securing bolt to 115 - 125 Nm.
Remove the chain tensioning tool and the wedge(s).
15. Remove the camshaft locking tool 303-530.
16. Raise the vehicle on the ramp.
17. Remove the crankshaft setting tool 303-531.
18. Install the crankshaft position sensor.
Install the sensor to the flywheel housing and install the securing bolt. Tighten to 8 - 12 Nm.
Install the access grommet to the housing.
19. Lower the ramp.
