XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-523003.png)
10. Tighten the center bolt.
This will draw out the seal and tool assembly which will be supported by the two bolts.
11. Remove the two bolts to release the tool and seal assembly from the crankshaft.
Remove the three self-tapping screws.
Remove and discard the seal.
Unscrew the center bolt until it is below the face of the tool.
12. Clean all relevant components.
Installation
1. Ensure that the transit sleeve is correctly in place and install the new seal over the crankshaft.
Do not use any lubricant on the seal, the transit sleeve or the crankshaft.
2. Carefully remove the transit sleeve, leaving the seal in place.
3. Install the tool to the crankshaft.
Ensure that the center bolt is unscrewed to below the face which is to install to the crankshaft and position the tool to the crankshaft.
Check that the nuts are fully unscrewed and enter the two bolts to the crankshaft threads and lightly tighten.
