XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
4. Tighten the nuts, finger tight, to hold the tool assembly against the seal. Check that the seal and the tool are approximately parallel to the rear of
the engine.
5. Press the seal into the housing.
Hold each bolt stationary, in turn, and tighten its nut a small amount (approximately two to three flats) in turn, to press the seal fully into the
housing, until the tool is in contact with the cylinder block.
6. Remove the tool from the crankshaft.
Check that the seal is located correctly.
7. Install the drive plate.
8. Install the transmission.
9. Remove the paint protection sheets and close the engine compartment cover.
10. Connect the battery and install the battery cover.
Reset the side glass memory.