XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
32. Remove the tappets and shims.
Note the position of each tappet, for reassembly, and remove each tappet and shim assembly - retain each shim with its original tappet.
Mark the inside face of each tappet in pencil or felt tipped pen, with its original position within the cylinder head.
33. Remove residual coolant from the cylinder head.
Place a drain tray under the engine.
Use a syringe with a length of thin rubber pipe connected, to drain the residual coolant from the outlet pipe water-way.
A suitable syringe is Snap On YA 745.