XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-530012.png)
12. Connect the coolant hoses to the throttle body.
Remove the blanking plugs from the hoses.
Connect the coolant feed hose and secure with the clip.
Connect the coolant return hose and secure with the clip.
13. CAUTION: Under no circumstances may the quadrant be held clear of the throttle stop by cable tension.
Install the throttle cable and ensure that there is neither tension nor slack in the cable.
Tighten the locknut without altering the setting or introducing twist into the cable outer.
Check the kickdown setting using the PDU. For scan tool procedure, Throttle Cable Renew.
14. Reconnect the multi-plugs to the throttle body.
Connect the throttle body motor multi-plug.
Connect the two potentiometer multi-plugs, one each side of the throttle.
Connect the vacuum pipe elbow to the throttle actuator.
