XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-532010.png)
20. Install the pulley to the water pump.
Install the pulley to the water pump.
Install the pulley securing screws. Tighten as far as possible; then to the correct torque after the belt has been installed.
21. Install the drive belt to the generator and accessory drive.
Locate the belt around the pulleys, except the generator pulley.
Use a spanner e.g. Churchill JD-230 or Snap On XDHM 1415, on the center bolt of the belt tensioner idler pulley, to turn the adjuster assembly to
the left against spring tension.
Whilst holding the tensioner against spring tension, connect the drive belt to the generator pulley.
Release the tensioner slowly and remove the spanner.
22. Tighten the three screws which secure the water pump pulley, to 10 - 14 Nm.
