XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-539006.png)
9. Install the crankshaft position sensor.
Install the sensor to the flywheel housing and fit the securing bolt. Tighten to 8-12 Nm.
Install the access grommet to the housing.
10. Lower the ramp.
11. Move the engine compartment cover from the service position and connect the gas struts.
12. Remove the paint protection sheets and close the engine compartment cover.
13. Connect the battery and install the battery cover.
Reset the side glass memory.
