XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
Crankshaft Setting Peg 303-531/645
Special service tools
Removal
1. Open the engine compartment and fit paintwork protection sheets.
2. Set the engine compartment cover to the service access position.
3. Open the driver's door, or both doors if necessary, to allow the side glass to drop. Ensure that the doors remain open until after the battery has been
disconnected.
4. Disconnect the battery ground cable.
Remove the battery cover.
5. Remove the Timing Cover.
6. Remove the VVT bush carrier from Bank 1.
Remove the three bolts which secure the carrier to the cylinder block.
Release the carrier from the two ring dowels and remove it.