XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-544008.png)
Crankshaft Setting Peg 303-531/645
Special Service tools
Removal
1. Open the engine compartment and fit paintwork protection sheets.
2. Set the engine compartment cover to the service access position.
3. Open the driver's door, or both doors if necessary, to allow the side glass to drop. Ensure that the doors remain open until after the battery has been
disconnected.
4. Disconnect the battery ground cable.
Remove the battery cover.
5. Remove the Timing Cover.
6. Remove the Variable Valve Timing Bush Carrier Assembly.
7. Raise the vehicle on a ramp.
8. Remove the crankshaft position sensor.
Remove the bolt which secures the crankshaft position sensor to the flywheel housing.
Remove the sensor and allow it to hang free under the engine.
