XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-566007.png)
12. Install the crankshaft position sensor.
Install the sensor to the flywheel housing and install the securing bolt. Tighten to 8 - 12 Nm.
Install the access grommet to the housing.
13. Lower the ramp.
14. Install Bank 1 VVT Bush Carrier Assembly.
15. Install the Timing Cover.
16. Move the engine compartment cover from the service position and connect the gas struts.
17. Remove the paint protection sheets and close the cover.
18. Connect the battery and install the battery cover.
Bank 2
Variable Valve Timing Unit - Bank 2
Special Service tools
Removal
1. Open the engine compartment and fit paintwork protection sheets.
2. Set the engine compartment cover to the service access position.
3. Open the driver's door, or both doors if necessary, to allow the side glass to drop. Ensure that the doors remain open until after the battery has been
disconnected.
