XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-567002.png)
7. Remove the seals from the bush carrier.
Remove the sealing ring (scarf jointed) from the carrier bush groove.
Remove the O-ring from the carrier oil-way recess.
8. Clean and inspect all relevant components.
Installation
1. Install new seals to the bush carrier.
Install the new sealing ring (scarf jointed) to the carrier bush groove.
Install a new O-ring to the carrier oil-way.
2. Install the bush carrier to the cylinder block.
Lubricate the seal (scarf jointed) and the bush.
Install the bush carrier assembly.
Check that the seals are in place and that the ring dowels are engaged squarely. Fully locate the assembly as much as possible by hand pressure.
Install the three securing bolts. Tighten to 19 - 23 Nm.
3. Install the Timing Cover.
4. Move the engine compartment cover from the service position and connect the gas struts.
