XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-994009.png)
11. Install the crankshaft setting peg to the crankshaft position sensor location.
Install the crankshaft setting peg.
Position the crankshaft so that the setting peg engages fully into the timing slot.
Install and tighten the bolt to secure the setting peg.
12. Remove the damper securing bolt from the crankshaft.
13. Lower the vehicle on the ramp.
14. Install the camshaft locking tool 303-530 to Bank 2 camshafts, aligning the shafts slightly as necessary.
15. Loosen the bolt which secures the sprocket to the exhaust camshaft.
