XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
Fuel Rail: Service and Repair
The fuel rails which run the length of each cylinder bank and are integral with the air intake manifold.
A cross-over pipe connects the two fuel rails together at the front of the manifold.
Pipe - Inlet Manifold Fuel Cross-Over
Removal
WARNING: BEFORE PROCEEDING, IT IS ESSENTIAL THAT ALL 'SAFETY PRECAUTIONS' ARE READ AND UNDERSTOOD.
1. Depressurize fuel system. See: Fuel Filter/Fuel Pressure Release/Service and Repair
2. Disconnect battery ground cable. See: Starting and Charging/Battery/Battery Cable/Negative/Service and Repair
3. Remove inlet manifold fuel cross-over pipe.
-
Place cloth under pipe elbows to collect any spillage.
-
Remove elbow securing screws.
-
Disconnect first elbow.
-
Disconnect remaining elbow and remove assembly.
-
Discard O-ring seals from pipe elbows.
-
Clean relevant parts and mating faces.
Installation