XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
11. Disconnect throttle cable from pedal
NOTE: Operate throttle pedal to gain access
Remove throttle cable to pedal split pin
Remove cable retaining sleeve
12. From under the hood, remove the cable from the vehicle
Installation
1. Installation is the reverse of the removal procedure. However, particular attention must be paid to the following
2. Refit the throttle cable & adjust the locknuts to achieve the specified gap between the quadrant & abutment as shown
Tighten the locknut without altering the setting or introducing twist into the cable outer