XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-1738003.png)
14.
Take the bushing to the press and, with the spacer in position on the bushing flange, place the bushing and spacer under the press ram and then
align the bushing with the centerline mark.
15.
When the bushing is in position, quickly press the bushing in.
Note:
The adhesive application and pressing operations must be completed in 4 - 6 minutes.
16.
Wipe off all excess adhesive from the subframe and the bushing. Remove the masking tape.
17.
After the bushing has been pressed into the subframe, check for any clearance between the bushing flange and the subframe (Illustration 4). If a
gap is present, it must not exceed 1.5 mm.
18.
Repeat the operation for the other bushing.
Note:
The subframe assembly should not be reinstalled until at least 4 hours have elapsed, to allow the adhesive to 'cure'.
19.
The 3 void bushing, shown in Illustration 5, was installed from VIN 21348 and is the bushing listed in Parts Information. This bushing is used to
replace the earlier type if replacement is necessary.
Note:
The 3 void bushings must be positioned as shown in illustration 5, with the middle void to the front and the solid area to the rear.
Parts Information:
