XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
10. Using a hydraulic press, remove wheel bearing from vertical link.
NOTE:
Make sure the vertical link is level, and the supports are situated as near to the bearing bore as possible.
a. Position the vertical link so that the inboard side of the bearing bore is resting on suitable supports on the press-bed.
b. Position special tool on top of bearing.
c. Operate press to remove bearing from vertical link, discard bearing.
11. Clean relevant parts.
Installation
NOTE:
The gap between the ears of the circlip must be positioned so that it is in the lowest position of the bore when the vertical link is fitted to
the vehicle.
1. Fit outboard circlip to the vertical link.
2. Using a hydraulic press, fit wheel bearing into the vertical link.
a. Position vertical link on the press bed with outboard side of the vertical link face down.