XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
/v8-4.0l_(aj26)/Page-1996003.png)
5. Mark bush position on sub-frame.
Stretch a length of thin cord across the center line of each bush location.
Below the string, place two pieces of masking tape diametrically opposite on the bore periphery.
Mark string position on the masking tape.
6. NOTE: New bushes are bonded in position using a rapid drying adhesive Application of this adhesive and fitting of the bush must be completed
within 3 minutes. It is therefore strongly recommended that the procedure is rehearsed to ensure it can be completed within that period.
Position subframe on a hydraulic-press.
Position special tool 204-116-02 on press-bed, with recesses uppermost.
Position subframe on top of tool.
