XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
7. Install the induction elbow support; working from the left hand side.
Install the upper bolt to the induction elbow support bracket. Tighten to 16-20 Nm.
Tighten the lower two bolts at the induction elbow support bracket. Tighten to 16-20 Nm.
Connect the engine breather T-piece to the induction elbow.
Connect the vacuum pipe to the front of the induction elbow.
8. Install the induction elbow support; working from the right hand side.
Install the upper bolt to the induction elbow support bracket. Tighten to 16-20 Nm.
Reconnect the vacuum pipe to the center of the induction elbow.
9. Install the throttle body.
Install a new gasket to the throttle body.
Position the throttle body to the induction elbow.