XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Removal
WARNING: ENSURE THAT THE ENGINE IS COLD BEFORE COMMENCING WORK
1. Disconnect the battery ground lead.
2. Remove the engine cover.
3. Slacken the coolant reservoir cap to relieve coolant pressure & re-tighten.
4. Disconnect harness plug from the ECT sensor, remove the sensor & sealing washer.
Installation
5. Fitting is the reverse of the removal procedure, noting that a new sealing washer should be used & tighten the sensor as specified.