XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
/v8-4.0l_(aj26)/Page-1253002.png)
6. Secure the driveshaft wrench 205 - 053 to the output shaft flange.
7. Remove the output shaft flange.
Using a suitable tool, relieve the 'staked' portion from the output shaft keyway.
Remove and discard the flange nut using a suitable socket and resisting rotation with special tool 205-053.
Check the flange seal diameter for damage and renew if necessary.
8. Remove and discard the oil seal.
Use a proprietary seal removing tool, taking care NOT to damage either the shaft or the housing.
Installation
1. Installation is the reverse of the removal procedure noting the following:
2. Fit the oil seal.
Lubricate the housing seal bore.
Lubricate the outside diameter of the seal.
Using seal replacer 307 - 378 drive the seal squarely into position.
