XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
2. Align the driveshaft with the transmission drive flange using the marks made on removal.
Tighten the three bolts to the specified torque figure.
3. Raise the transmission carefully to position, using the transmission jack
4. Fit the engine rear mounting and tighten the center bolt and outer bolts to the specified torque figures.
Check that the safety chain on the transmission jack will not be trapped when the mounting is fitted.
5. Remove the transmission jack.
6. Check the transmission fluid level.
Rear Extension Housing Oil Seal
Rear Extension Housing Oil Seal
Removal
1. Remove the rear extension housing.