XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
/v8-4.0l_(aj26)/Page-1361004.png)
Using a prybar, or similar, expand the circlip into its undercut by applying outward radial pressure. Start diametrically opposite to the circlip open
ends & lever against the drive flange.
6. Verify the circlip location.
The gap MUST be greater than 10.0 mm
CAUTION: If the gap CANNOT be achieved, contact Jaguar Service.
A gap smaller than specified will indicate an improperly fitted circlip. This may be rectified by refitting or by the application of radial pressure
around the inner circumference of the circlip.
7. Verify that the output shaft end-float is within specification.
8. Refer to the illustration.
If appropriate realign the previously made match marks.
9. Check the final drive oil level & adjust as required.
10. Check & adjust rear wheel camber setting.
