XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
Control Module: Service and Repair
Transmission Control Module (TCM)
Removal
1. Open the driver's door, or both doors if necessary, to allow the side glass to drop. Ensure that the doors remain open until after the battery has been
disconnected.
2. Disconnect battery ground cable.
Remove the battery cover.
3. Release the fixings and remove the cover from the ECM / TCM housing.
4. Disconnect the TCM harness multiplug EM007.
5. Lift the TCM from its housing.
Installation
1. NOTE: A replacement TCM may only be obtained from an authorized Jaguar dealer and MUST be ordered against the VIN,
Fitting a new TCM is the reverse of the removal procedure.