XK-8 Coupe (X100) V8-4.0L (AJ27) (1999)
/v8-4.0l_(aj27)/Page-1255004.png)
16. Place assembly on bench, slacken and remove screws securing lift motor to regulator and remove motor.
Installation
1. Position lift motor on regulator assembly and fit and tighten securing screws.
2. Close scissor mechanism and pass assembly through aperture into door.
3. Position motor/regulator assembly in door.
4. Fit but do not tighten motor to door securing screws and regulator channel securing nut.
5. Position regulator channel securing stud in elongated hole as measured during removal and fit and fully tighten securing nut.
NOTE: Accurate positioning of this stud is critical to glass alignment.
