XK-8 Coupe (X100) V8-4.0L (AJ27) (1999)
/v8-4.0l_(aj27)/Page-1272002.png)
3. Remove nut and washer from tool.
Position special tool 204-116-06 on bush with recesses accommodating the bush rebound stops.
Install washer and nut on tool, but do not tighten nut at this stage.
4. Invert subframe and position assembly on special tool 204-116-02, with subframe located in the recess.
5. CAUTION: Ensure special tool 204-116-06 is correctly aligned and does not contact the bush housing bore.
Remove bush from subframe.
Align assembly with the press-ram.
