XK-8 Coupe (X100) V8-4.0L (AJ27) (1999)
5. Depress and hold down the brake pedal to the specified position using the special tool.
-
Position tool between brake pedal and seat frame.
-
Turn the tool wheel until the brake pedal is held 60 mm down from its released position.
6. Tighten bleed nipples to:
-
Front caliper bleed nipple 4 - 6 Nm.
-
Rear caliper bleed nipple 8 - 11 Nm.
-
Remove bleed tubes and containers.
7. Disconnect upper electrical connector.
-
Pull plunger upwards.
-
Release connector.
8. Position an absorbent cloth underneath the brake control modulator to collect brake fluid spillage.
CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.