XK-8 Coupe (X100) V8-4.0L (AJ27) (1999)
/v8-4.0l_(aj27)/Page-947003.png)
9. The upper bolt may be removed (after loosening) using a 3/8' square drive 13 mm socket, extensions and U.J as shown.
Installation
1. Installation is the reverse of the removal procedure. Tighten the starter motor securing bolts to 38-48 Nm.
2. Refit the steering rack. Refill the reservoir with the recommended fluid and bleed the steering system.
3. Lower the ramp. Remove the protection sheets and close the engine compartment cover.
4. Connect the battery and fit the battery cover. Refer to the Battery Reconnection Procedure. See: Battery/Service and Repair
