XK-8 Coupe (X100) V8-4.0L (AJ27) (1999)
Shift Cable: Adjustments
Selector Cable - Adjust
1. Open the driver's door, or both doors if necessary, to allow the side glass to drop. Ensure that the doors remain open until after the battery has been
disconnected.
2. Disconnect battery ground cable.
Remove the battery cover.
3. Position the shift to N.
4. Remove the J-gate surround.
5. Remove the console finisher veneer panel.
6. Remove the center console assembly.
7. Slacken the selector cable locking nuts away from the abutment.
8. Raise the vehicle for access.
9. Verify the transmission selector position (N)
At the transmission, detach the inner cable from the selector lever.
With the lever moved fully rearward, push the lever forward two detents to achieve N.
Reconnect the inner cable.