XK-8 Coupe (X100) V8-4.0L (AJ27) (1999)
/v8-4.0l_(aj27)/Page-742002.png)
7. Remove harness multiplug retaining clip.
Push the multiplug into the transmission casing to release.
Discard the two 'O' rings.
Installation
1. Installation is the reverse of the removal procedure noting that:
2. Lubricate the new 'O' rings prior to fitting.
3. Tighten the securing bolts, selector cable bracket to transmission casing, to the specified torque figure.
4. Perform the Battery Reconnection Procedure described in Starting and Charging.
5. Refer to fluid fill procedure. See: Fluid - A/T
