XK (X100) V8-4.2L SC (2003)
-
Remove bolts.
15. Release crossbeam rear mountings from body.
-
Remove center bolt.
-
Repeat procedure to release opposite-side mounting from body.
16. CAUTION: Take care not to damage power steering hydraulic-pipes when lowering crossbeam.
Lower crossbeam sufficiently to remove rear mounting.
17. Remove rear mounting.
18. Clean relevant parts.
Installation
1. Apply Loctite 270 or 243 to the rear-mounting captive bolt.
2. Position rear mounting to crossbeam.
3. Secure rear mounting to crossbeam.
-
Align mounting.
-
Fit and tighten bolts.
4. Raise crossbeam.
5. Secure crossbeam rear mountings to body.
-
Fit and tighten bolt.
-
Repeat procedure to secure opposite-side mounting to body.
6. Lower and remove jack from beneath crossbeam.